555-Room-Challenge-1 Let there be light!

Let there be light!

Today as part of the 555 Room Challenge I’m going to share with you a simple to follow tutorial for how to replace a ceiling fan with a flush mount light. I will be sharing my final project and the big reveal later on today!

If you want to check out my other DIY projects for the 555 Room Challenge here they are:

Be Green With Envy

I admit it…I’m a Gold Freak

Glowing Green With Envy

To many installing a light fixture is self-explanatory. To those who it isn’t (like me), here’s a quick tutorial on how to remove a ceiling fan and putting up a light. You only need two tools! Yes I said that right, two tools!

Tools Needed:

Voltage Tester

Screwdriver

 

  1. Turn off the power to the breaker box. If your light or fan turns off you found the right breaker!
555-Room-Challenge-1 Let there be light!

2. Remove the fixture you are replacing. In my case it would be a ceiling fan.

555-Room-Challenge-1 Let there be light!

3. Double check there is no power using your voltage tester. Notice how the tester lights up red when there is electricity present.

555-Room-Challenge-1 Let there be light!

See no electricity because there is no red light. 

555-Room-Challenge-1 Let there be light!

4. After installing your mount plate, be sure to attach the ground wires from the fixture and the electrical wiring to the plate using the green ground screw. Both of my ground wires were copper but yours may be green.

555-Room-Challenge-1 Let there be light!

5. Black wires, one from the fixture and one from the electrical wiring, are twisted together and secured with one of the included wire nuts. Twist clockwise until tight. Do the exact same with the white wires.

555-Room-Challenge-1 Let there be light!

6. Before putting everything together, make sure it works. Add a light bulb, turn your breaker back on and flip the switch.

555-Room-Challenge-1 Let there be light!

7. Once you are sure it is working, turn your breaker and switch back off.  You can now install your fixture to its mounting bracket. Be sure not to pinch or pull any wires when lining the fixture up to the bracket. There is usually three or four screws around the lip of the fixture to screw into the bracket. 

555-Room-Challenge-1 Let there be light!

8. Turn your breaker back on and test again.

555-Room-Challenge-1 Let there be light!

9. Install your shade as per manufacturer’s instructions. 

555-Room-Challenge-1 Let there be light!

Leave a Reply